Of course, depending on the make and model of the car, you might be able to sneak in a small LCD screen without anyone noticing.īy way of introduction, I am Mark Schaefer, and I represent Nutritional Products International. If you wanted to, the system could also be configured with different colors corresponding to various possible fault conditions.Ĭompared to some of the more aggressive dashboard updates we’ve seen, this is an interesting compromise that helps retain the look of the original instrumentation. As demonstrated in the video below, the whole gauge can light up bright red to indicate a critical situation such as low oil pressure. On the speedometer side, the LEDs seem to be used primarily as warning indicators. It will also light up the LEDs to follow the analog gauge as it moves around, which might not have much practical application, but certainly looks cool. The firmware running on the CAN equipped Adafruit Feather M4 can do things such as light up a dynamic redline based on current engine temperature. So far, it looks like most of the work seems to have been put into the tachometer. LEDs can easily shine through the gauge face. When the LEDs are off you’d never notice them, but once they kick on, the light is clearly visible through the material. Rather than replace the analog gauges entirely, rings of RGB LEDs of the same diameter were placed behind their matte black faces. Whether its seven segment LEDs or a full-on graphical interface powered by the Raspberry Pi, the end result is the same: a dashboard that looks wildly different than it did when the car rolled off the assembly line.īut this LED dashboard project from takes a slightly different approach. We’ve seen several so-called “digital dash” upgrades over the years that either augment, or completely replace, a vehicle’s original dashboard indicators with new displays.
0 kommentar(er)
